Silly question: CG Spray nozzles

[topspin2006]

The nozzles seem kinda long for the 16oz bottles. Do you cut them or will it bend in?

 

[imported_smprince1]

Either way should be fine.

 

[imported_Padron]

I just bend them into the bottle, works fine.. :hifive:

 

[RCBuddha]

I cut mine

 

[HondaGuy]

Ya, I just bend them too. Not sure why they are longer... my guess is the bottles were bought from one place and the sprayers from another in order to get the cheapest possible. LOL

 

[benvegas]

Those sprayers are made by Tolco in Ohio. They are one of the best shippable sprayer nozzles I've seen. Tolco was indeed hitting the pipe hard, as the length is about 2" too long on each sprayer -- even for Tolco bottles! If you bend them you might end up kinking it like a garden hose over time, so just snip it at an angle much like you would a dozen roses to make sure they suck up enough water.



-Ben

 

[3Dog]

Srayer tubes are made longer so the will wrap around the bottom of the bottle. This helps to keep the tube at the bottom as opposed to try to get a correct length on a straight tube..then maybe its to short and waste product at the bottom or too long and suction is restricted.

 

[GearHead_1]

I think they use the tube for two different sized bottles (16 and 32 oz.).

 

[Zrex61]

Just cut it off completely & use the bottles upside down... thats what I do when I'm wetsanding...

 

[benvegas]

Usually the length is long enough to snake around the bottom, but not on these, the hose section is too hard to snake anywhere. My recommendation to snip at an angle still plays.