Black OXO Wash Brush

K

k80

New member
I recently detailed a car and used my OXO Wash Brush. The under side of one of the sills must have been covered in tar as my OXO Wash Brush is now black. I allways use the two bucket method but the brush would not rinse clean. Once home I tried again to rinse the brush clean using a APC but with no luck, the brush still remains black. Im now worried of using the brush on my car incase it will damage the paintwork.



What else can I try to clean the brush and will it be ok to use even though it is black?
 
I had the same problem with my Oxo tyre brush - one use and it was dark grey. Not too bothered though as it's only used for tyres. I tried APC+ and Fairy without success.
 
i had that happen with my oxo wash brush once. not as bad as yours, but i left it in a bucket with the about 1 inch of the brush soaking in simple green. left it there for about a week (forgot about it :)) and it washed clean. you could try a tar remover on it, or goo-gone or something?
 
My OXO wash brush has since become grey with use, so after use, I spray an amount of diluted APC+ onto the bristles and let soak in for a bit.



I then lay an old (clean and dry) terry style towel out on the floor and repeatedly scrub the brush over the towel surface. A few passes of this (and further applications of APC+) and the bristles gain their 'near' as new appearance.



I have done the same with the wheel brush, which gets dirty very quickly.
 
You must log in or register to reply here.
Back
Top