Recent content by OllieJay

Hello,   Just over 2 weeks ago I  opti coated my 13' Jetta wagon. I went to a vacation cabin which the water comes from a well. This well water usually runs through a water softener and a uv light, unfortunately I found out the hard way that there was an issue with the water softener system...

Hey guys I got a job doing 3 beautiful motorcycles, you can see the sneak preview photos of what I have to work with below. I've ran into a minor problem doing some of the polished pieces on two of the bikes; see photos and info below: On this piece the customer was wanting get rid of the...

Hey guys, Here's a slideshow video of a HORRENDOUSLY disgusting Black Dodge Durango I did. I almost had a heart attack when I saw how bad the Holograms on the hood were, along with how badly oxidized it was, as you can see it also had some nasty wash induced spider-marks to say the least...

Hello, This particular customer I have had a unfortunate event happen to him: While cruisin down the freeway the power steer reservoir cap came flying off and right behind that the power steering fluid went everywhere. As you can see in this picture I've pointed out where the fluid had crept...

Hey guys, Well after doing some reading and research on what extractor to get, it sure wasn't too hard to decide that the HP100 was going to be the best bet to go with. Well here's how its goes: Ordered from: AUTOGEEK Employee: Penny (Good customer service and very kind)...

Hello, I have a customer that would like paint correction on both of his vehicles - Black 07' Ford F150 Harley Davidson & Black 07' Audi a6 turbo. As I have no experience with these vehicles as far as paint correction goes, I'd like to see if you guys have any experience/opinions regarding...

Well with nothing else to do and having a neglected black Pontiac sitting in the driveway I thought I practice my polishing skills and do a wax test. I used the Makita 9227c and started off with M105 using a orange light cutting pad which was followed by M205 with a white foam polishing pad. I...

Gentlemen, I have a customer that just had one side of the his Acura TL re-painted (2 days ago). My question to you guys is how long do you figure until its safe for me to touch paint ? Because from what I understand - correct me if I'm wrong - the paint has to cure for a certain period of...

This is a Work in progress and thought I would give you guys a sneak peek on what I'm working on, I'll call this one Project: OXYCLEAN haha. This Mustang belongs to a friend of mine so I told him that I wouldn't mind working on it to see what kind of a result I could get. It sits uninsured in...

Hey guys, I'm from Vancouver - home of the 2010 winter Olympics as you may know - I stumbled upon this website while surfing the internet. Around the age of 10 I started cleaning cars, ever since then I've loved doing it. Currently I've started my own mobile detailing service - Jetwash -...